SJVWC Forums

Archive => Archive board => Engine Shop => Topic started by: vwtrike (Rich) on November 20, 2008, 06:40:39 pm

Title: intake manifold
Post by: vwtrike (Rich) on November 20, 2008, 06:40:39 pm

I bought a new after macket intake manifold from CIP1. My problem is the right side does not go into the end part. It's 7/16 shorter then the stock manifold. It's 1/16 of an inch from touching the end part. I don't know if this is right.  S@Sm

Title: Re: intake manifold
Post by: lovebus (jack) on November 20, 2008, 08:34:15 pm

Thats not right, call them tomorrow.

Don't that just piss you off!!!