ok well I got around to adjusting the valves on the bus. I got through #1 and #2, with little trouble. (#2 was very tight)
I went to start numbers 3 and 4, I realized the valve cover spring was not going to go down past the heater box. I installed the 74 style and this was the first time I had tried. I pushed it up knowing I would regret it later. the first thing I noticed that it was missing the small thin clip that sits around the push rods. I had a spare floating in my parts bucket, and when I went to install it I noticed this.......(http://farm3.static.flickr.com/2450/3568627424_8c2e21bf3b.jpg)
the assembly seems to be wrong. the "space" is on top. do you think this will be aproblem, should I leave the clip out?
any tips on getting the clip down over the valve cover?
(milo) Ghug fig2 busicon2 sqBk fast@#
Your this far, you may as well take it off and flip it over.
Put a wire around the clamp so you can pull it down.
Quote from: LoveBus (jack) on May 26, 2009, 08:54:44 PM
Your this far, you may as well take it off and flip it over.
Put a wire around the clamp so you can pull it down.
I didn't know if it was a simple step or something that was going to be more involved. I will have at it later on.