I recently tore down a running single port type 1 engine. I only needed the heads, case, cylinders and cylinder tins for mocking up my linkage system. Does anyone have interest in the internals???? Pistons, lifters, cam, crank, rods, fuel pump, flywheel, clutch pressure plate, etc. All items are free. I figure I would ask before heading for the scrap yard :)
hey Pete, I'm always intrested in free parts. Your in PA, right? I can come over this week.
I'll take em.
john
Quote from: 6T5 square on August 19, 2012, 03:15:27 PM
hey Pete, I'm always intrested in free parts. Your in PA, right? I can come over this week.
I'll take em.
john
Thier yours, John. I'm home everynight by 5 pm and I'm off fridays and saturdays :)
Slowtwitcher..
Gots any T3 stuff your selling off?
:grin:
Quote from: 6T5 square on August 19, 2012, 03:15:27 PM
hey Pete, I'm always intrested in free parts. Your in PA, right? I can come over this week.
I'll take em.
john
Hey John I could use the cam if it is a stock 1600. I'll pay you twice what it cost you. :grin:
Quote from: ChoppedSq on August 19, 2012, 04:07:46 PM
Slowtwitcher..
Gots any T3 stuff your selling off?
Sorry, no type 3 stuff
hey Howard- let me see what I got and then I can tell you
((thumpup
hey Howard- Sorry buddy but these parts are exactly what I need. If I give you the crank, I'll have to find another one. And these all match.
Again, sorry buddy.
No problem. Shawn might have one or I'll just buy a new one.
Thanks.
Quote from: buglvw (Howard) on August 24, 2012, 07:12:09 PM
No problem. Shawn might have one or I'll just buy a new one.
Thanks.
Howard, i'm going to a VW fleamarket in the morning. I'll get ur cam!