nah i got nothing not craking all fuses are good. goin to look at it tomorrow.
Absolutely nothing? No click, no whine...nothing?
Do other electrical items function OK? If so loosen, clean & re-tighten the fat cable going to the starter & remove clean & reseat the push-on connector on the solenoid.
If not... Remove, clean & reinstall battery cables AND the ground strap's attachment to the pan
Try it again. If still nothing Put a test light on the fat cable it should light. If not check battery cable has a problem
Putting the light on the small wire should light when key is turned. If not trace back to ignition switch.
If you get light on both and jumping the two with a remote starter switch* aka screw driver gets nothing, rap the solenoid with a hammer (not too hard)
If still nothing... smack the starter a couple of times and try again. If still nothing... it's probably the starter
* Remote starter switch

Everyone should have one of these. takes 2 seconds to clip on the starter & you can start the engine from the engine bay.
Beats the heck out of getting up & going op to the key & then running back before it stalls