rocker arms

Started by rockdog2877, May 26, 2009, 07:59:50 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

rockdog2877

May 26, 2009, 07:59:50 PM
ok well I got around to adjusting the valves on the bus. I got through #1 and #2, with little trouble. (#2 was very tight)
  I went to start numbers 3 and 4, I realized the valve cover spring was not going to go down past the heater box. I installed the 74 style and this was the first time I had tried. I pushed it up knowing I would regret it later. the first thing I noticed that it was missing the small thin clip that sits around the push rods. I had a spare floating in my parts bucket, and when I went to install it I noticed this.......

the assembly seems to be wrong. the "space" is on top. do you think this will be aproblem, should I leave the clip out?
any tips on getting the clip down over the valve cover?


(milo) Ghug fig2 busicon2 sqBk fast@#

lovebus (jack)

#1
May 26, 2009, 08:54:44 PM
Your this far, you may as well take it off and flip it over.

Put a wire around the clamp so you can pull it down.
I don't have to go to work in the morning....

RT 66 June 1, 2015

"Why restore it to its former short comings
When you can modify it too its full potential."

rockdog2877

#2
May 26, 2009, 09:02:06 PM
Quote from: LoveBus (jack) on May 26, 2009, 08:54:44 PM
Your this far, you may as well take it off and flip it over.

Put a wire around the clamp so you can pull it down.

I didn't know if it was a simple step or something that was going to be more involved. I will have at it later on.
Print
Go Up Pages1
User actions