An update.

[Celly]

Yes I did! Thanks for asking...did you ever get all your tin?

[rockdog2877]

I dunno about all the tin. might be one short. split the block tonight, here is what I found.....

[lovebus (jack)]

I can't make out what your showing (chunk of bearing) but it also looks like the rear main bearing was spinning in the case. I sure would like to come up and check it out before you put it back together.

[rockdog2877]

I can't make out what your showing (chunk of bearing) but it also looks like the rear main bearing was spinning in the case. I sure would like to come up and check it out before you put it back together.

the one picture has a hunk of the rear bearing.
the bottom picture I was showing the cam bearing was down to the copper.
Feel free to stop by anytime.

[rockdog2877]

what's the best way to get a seized bearing off the crank?
lol a new crank?

[Bob(Herbie)]

Is it a half or whole bearing? Probably whole! I have cut them off using an air powered cut off wheel, using a wheel the is very small (almost worn out). Don't touch the crank!!!!!!! When you get close carefully knock it off with a small chisel.
Good luck,
Bob "Herbie"

[Baha (Shawn)]

what's the best way to get a seized bearing off the crank?

Take it to Jack's.

[6T5 square]

yeah, when I see an old broken crank, I think of Jack.







hee hee hee!

[lovebus (jack)]

yeah, when I see an old broken crank, I think of Jack.

hee hee hee!

[Baha (Shawn)]

yeah, when I see an old broken crank, I think of Jack.







hee hee hee!