What did you do to your VW today?

[6T5 square]

why did you have to check the brakes in the first place? Peace of mind or was there an issue?

[6T5 square]

OK Bud... What's a 4" Solar Vent?

I dont know my bus history very well, but didnt those late models come with a small plastic crank vent on top of the van to let out interior heat?

[Jack Kessel]

why did you have to check the brakes in the first place? Peace of mind or was there an issue?

For peace of mind, because the backs where so bad when I got it, thought the fronts may be very low.

[66-Ghia]

My bad, meant SOLAR vents

Google 4 inch SOLAR vents for boats etc.

OK Bud... What's a 4" Solar Vent?
[/quote]

[bugs2much]

Front or middle?

put it at the location that is easiest to load and unload

[Baha (Shawn)]

put it at the location that is easiest to load and unload

Great thought Jim!

Google 4 inch SOLAR vents for boats etc.

Ah solar powered vents...cool.

I'm going for the Generator powered vent...

[scarecrow]

Moved tools from back of Bus to underneath the bench seat & covered it up with luan & black carpet. Then I added carpet to the rear that matches main cabin. Got the curtains from Shawn & Jay scored the rods for me. Thanks Guys 

By no means done I have bunch more ideas including a way to install a bed & keep the bench seat.

[scarecrow]

Great thought Jim!

I like it in the front

[Jack Kessel]

nice job Mark.

[Baha (Shawn)]

Carpet & curtains look good Mark. Nice job

I like it in the front

Yeah, me too. It's not too bad to load from either door & the slider PLUS I can get off-road light brackets that mount on the basket rail.

[scarecrow]

Carpet & curtains look good Mark. Nice job

Yeah, me too. It's not too bad to load from either door & the slider PLUS I can get off-road light brackets that mount on the basket rail.

Off road lights along with those new tires is gonna look cool

[Jack Kessel]

I drove the hell out of it along with Paul, Mark, John and Jim..

[scarecrow]

OK, so I'm sitting @ the Bound Brook show admiring Jack's hot weather hood prop   thinking I could use one of those.  With the Rat form follows function, has to be simple (or simple minded ) & made from free stuff found around the garage.  Hmmm, let see, a clevis pin & clip to hold piece of scrap metal to bumper, a little tape to keep it from rattling, zip tie to hold hood down &  c clamp to hold everything firmly in place both when in use & folded away

[Jack Kessel]

How bout that, I was working on my hood prop also today to replace my board. (getting tired of John raging on me) It's not as complex as yours but will be adjustable.

[scarecrow]

How bout that, I was working on my hood prop also today to replace my board. (getting tired of John raging on me) It's not as complex as yours but will be adjustable.

Dam, mines not adjustable